US Trends

how to use charcoal chimney

If you’ve ever waited 20+ minutes for charcoal to catch while lighter fluid hissed away, a charcoal chimney is the cleaner, faster alternative: it lights your coals in about 10–15 minutes using only newspaper or a firestarter cube, no chemicals needed.

What is a charcoal chimney?

A charcoal chimney is a tall metal cylinder with holes near the bottom and a grate that holds the charcoal. It uses the “chimney effect” – hot air rising through the tube – to pull flame and heat up through the coals, lighting them evenly and quickly.

Step-by-step: how to use a charcoal chimney

1. Choose your firestarter

You have two main options:

  • Newspaper : 2 loosely crumpled sheets.
  • Lighter cubes / tumbleweeds : 1–2 cubes or a small firestick, according to the product instructions.

Avoid using “ready-light” charcoal that already has accelerant built in; it can burn too aggressively and is not necessary.

2. Prepare the bottom

  • Remove the bottom grate of the chimney.
  • If using newspaper:
    • Loosely roll or crumple 2 sheets (don’t make them tight balls; they need airflow).
    • Stuff them into the bottom chamber through the grate openings.
* Pull a couple of loose edges out through the holes so they’re easy to light.
  • If using cubes:
    • Skip the newspaper.
    • Place the cubes directly on the bottom grate or under the chimney as the manufacturer suggests.

Important safety note: Never place the chimney directly on concrete to light it; the heat can damage or crack the surface. Use the grill grate, brick, concrete paver, or another heat-safe surface.

3. Fill with charcoal

  • With the bottom grate back in place, fill the chimney to the top with charcoal briquettes or lump charcoal.
  • Use chunks larger than about 2 × 2 inches; tiny pieces can block airflow and make the fire struggle.
  • You can use less charcoal if you only need a small fire, but a full chimney usually gives the best, most even results.

4. Light it

  • Place the chimney inside your grill (on the grate) or on a heat-safe surface away from flammables.
  • Use a long-handled lighter or match to ignite the newspaper edges or the firestarter cube through the bottom holes.
  • Keep the grill lid off while lighting.

5. Let it work

  • Wait 10–20 minutes while the coals heat up.
  • You’ll see:
    • A little smoke at first.
    • Then the flames grow and the top coals start to glow.
  • The charcoal is ready when:
    • The top layer is partially ashed with a light gray/white coating.
    • Smoke is mostly gone or turning bluish/clear, not thick white.

You don’t need every piece to be fully ashy; you just want enough lit coals to carry the fire when you pour them.

6. Pour the coals

  • Put on heat-resistant gloves and wear closed shoes (small bits can fall through).
  • Grab the chimney with both hands.
  • Give it a quick shake to drop loose ash through the grate.
  • In one smooth motion, tip the chimney over the grill and pour the hot coals into the firebox or cooking area.

Tip the chimney onto a heat-safe surface after dumping, not on plastic, wood, or walkways.

7. Arrange for cooking

Now you’ve got a hot, even bed of coals:

  • For direct heat (grilling burgers, veggies): spread the coals in a single layer under the cooking area.
  • For indirect heat (slower roasting, smoking): pile coals on one side or in two zones, leaving the middle empty for the food.

Add a few extra unlit coals if you need a longer cook; they’ll catch from the hot ones.

Common mistakes and how to fix them

Mistake| Why it’s a problem| Fix
---|---|---
Tight newspaper balls| No airflow, paper won’t burn well| Loosely crumple 2 sheets; pull edges out to light 6
Tiny charcoal pieces| Blocks airflow, poor burning| Use larger chunks; avoid lots of “dust” 6
Lighting on concrete| Can crack or discolor the surface| Use grill grate, brick, paver, or heat-safe pad 89
Pouring too early| Coals aren’t hot enough to sustain fire| Wait until top is partially ashed and smoke is clearing 48
Pouring too late| Coals underneath burn out| Dump when top is 50–80% ashy, not fully ashed 24

Pro tips for better results

  • Use the grill grate as your base while lighting; any ash falls directly into the grill where you’ll pour the coals.
  • If you’re in a windy spot , lighter cubes or tumbleweeds can be more reliable than newspaper.
  • For long cooks , add a few extra fresh coals around the hot ones after pouring; they’ll catch gradually and keep the fire steady.
  • Always keep the lid and vents open while coals are lighting and heating the grill, then adjust for your target temperature once cooking begins.

Using a charcoal chimney is basically: paper or cube → fill → light → wait → dump → arrange. Once you’ve done it once or twice, you’ll be grilling in under 20 minutes with no chemical smell and a much more consistent fire.

Information gathered from public forums or data available on the internet and portrayed here.