Quick Scoop

Installing a wired Ring doorbell is mostly about turning off power, wiring the doorbell to your existing chime setup, mounting the device, and finishing setup in the Ring app. The official Ring guide says to turn off power at the breaker first, check transformer compatibility, connect the two wires to the back terminal screws, and secure the unit with the included screws and security screw.

[2]

What You Need

  • Phillips screwdriver.
  • Drill and 1/4-inch bit for brick, stucco, or concrete.
    • [2]
  • Included anchors, screws, faceplate, and security screw.
    • [2]
  • Existing doorbell wiring and a compatible transformer.
    • [2]

Install Steps

  1. Turn off power at the breaker before touching any wires.
    2. [2]
  2. Remove your old doorbell and keep the wires from falling back into the wall.
    3. [2]
  3. If required by your model, open the indoor chime and install the included jumper cable or bypass connection on the labeled terminals.
    4. [4][2]
  4. Use the doorbell as a template, mark the holes, and drill pilot holes if your surface needs anchors.
    5. [2]
  5. Connect one wire to each terminal screw on the back of the Ring unit and tighten them securely.
    6. [2]
  6. Tuck the wiring into the wall, mount the doorbell, restore power, and complete setup in the Ring app.
    7. [2]
  7. Reattach the faceplate and fasten the security screw at the bottom.
    8. [4][2]

Useful Tips

  • Ring’s instructions and installation videos show that wire order usually does not matter on the doorbell terminals.
    • [8][4]
  • If your wires are too short, some Ring models include wire extenders.
    • [1][8]
  • For masonry surfaces, use anchors; for wood or siding, you may not need to drill pilot holes.
    • [4][2]
  • Never skip the breaker shutoff step, because you are working with home wiring.
    • [2]

Common Mistakes

  • Forgetting to turn off power.
  • Losing the old wires back into the wall.
  • Mixing up the indoor chime wiring on models that need a jumper or bypass.
    • [4][2]
  • Using the wrong screws or not tightening the terminal screws enough.
    • [2]

Meta description: Learn how to install a wired Ring doorbell, from turning off power and wiring the chime to mounting the device and finishing setup in the app.

Bottom Note

Information gathered from public forums or data available on the internet and portrayed here.