Most Wemo smart plugs reset in a similar way: you either hold the physical button while plugging it in, or use the Wemo app’s reset options to do a factory restore.

Basic manual reset (most Wemo plugs)

These steps work for common Wemo WiFi Smart Plug models like WSP080.

  1. Unplug the Wemo smart plug from the wall outlet.
  1. Press and hold the power button on the plug. Keep holding it.
  1. While still holding the button, plug the Wemo back into the outlet.
  1. Continue holding the button for about 5 seconds, until the status light starts blinking (often white or amber/white depending on model).
  1. Release the button. The plug will reboot and enter setup mode, ready to be added again in the Wemo app.

Simple reboot (not factory reset)

If you just want to “power cycle” the plug without wiping settings:

  • Unplug the Wemo from the outlet.
  • Wait about 5 seconds.
  • Plug it back in and let it start up fully.

This can clear minor glitches without losing Wi‑Fi details or rules.

Reset using the Wemo app

If the plug still appears in your Wemo app and is somewhat responsive, you can reset it from there.

  1. Open the Wemo app and log in to your account.
  1. Tap Edit on the devices list, then select your Wemo smart plug.
  1. Go to Reset Options.
  1. Choose one of the following:
 * **Clear Personalized Info** – removes custom name, rules, stored data but keeps Wi‑Fi info.
 * **Change Wi‑Fi** – erases Wi‑Fi details and puts the plug back into setup mode, but keeps names/rules.
 * **Factory Restore** – full factory reset; wipes everything so you set it up like new.

After the reset: set up again

Once the status light indicates setup mode, walk through setup.

  • Open the Wemo app and choose to add a new device.
  • Connect your phone to the Wemo’s temporary Wi‑Fi or follow the on‑screen prompts for your specific model.
  • Enter your home Wi‑Fi name and password and wait for the plug to finish configuring.
  • Rename the plug (e.g., “Living Room Lamp”) and test turning it on/off from the app.

Quick HTML table (models vs reset)

[5][3] [5] [9][1] [1] [7] [7]
Wemo model Manual reset gesture Typical light behavior
Wemo WiFi Smart Plug (WSP080) Hold power button while plugging in for ~5 seconds.Blinks white, then enters setup mode.
Older Wemo Insight / Mini Press and hold reset or power button for about 5 seconds (often while powered).LED flashes to indicate reset, then shows setup status.
HomeKit- only Wemo plug Remove from Home app, then follow app flow to add again (acts like a reset).Reappears as new accessory in Apple Home after re‑adding.

Mini “Quick Scoop” recap

  • For a full factory reset , unplug, hold the button, plug back in, keep holding 5 seconds until the light blinks.
  • For a soft reset or Wi‑Fi change , use the Reset Options inside the Wemo app.
  • After resetting, you must set the plug up again in the app just like a new device.

Information gathered from public forums or data available on the internet and portrayed here.